Last seen: Oct 28, 2026
$32 is to enable or disable laser. There is nothing different between 'Laser' and 'CNC' except Z axis function. LaserGrbl is for laser, you can test...
Hi, There are two configurations you have to check: 1)$32, switch between CNC and Laser 2)$45, setup A as 2nd Y. 0: As Y axis, 1 as A, 2 as las...
Hi Andy, There are no settings to configure on the handwheel. Just plug it in and use it. Normally, there are two possible reasons for this issue: ...
Please refer user manual: $45 to configure 2nd Y, or A
The MKS DLC32 Max board, can use two Y axis seperately: Use A axis as 2nd Y. In this case, A axis is gone. So X YY Z, or XYZA
Hi Andy, would you mind to share your experience with our handwheel?
Speed mode: #define SERVO42D_SPEED_MODE 0xF6 void Servo42D_RunSpeed(void) { TxHeader.StdId=SERVO42D_ID; TxHeader.ExtId=0; TxHeader....
Case 1, get motor Mode status. Using this testing to verify the communication between STM32 Blue Pill, MCP2551 and Servo42D via CAN. #include "main....